Return checklist
From MITNA
Before leaving the boat
- Tidy up
- wipe kitchen surfaces
- sweep/wipe cabin floor
- sweep/wipe cockpit surfaces
- wash/scrub topsides with freshwater
- Complete log entry, including:
- date and time
- estimated engine hours and fuel level (use mechanical gauge underneath port salon bunk cushion)
- name of person making the entry
- description of trip, including destination, route, weather
- enumeration of things that were repaired, need to be repaired, will soon need to be repaired
- Remove ensign from stern and stow.
- Remove MITNA burgee and stow.
- Stow winch handles in tray in starboard lazarette
- Stow boat hook in starboard lazarette
- Replace metal binnacle cover if removed
- Ensure that mainsail is well-tied and covered
- Ensure that headsail is furled and secured, and jib sheets are tight
- Ensure that main halyard is attached to aft end of boom and boom is held level
- Ensure that the boom and sailcover will not touch the dodger
- Close hatches (there are 3) and window ports (there is 1)
- Place aluminum extrusions over forward and aft hatch interior handles to lock them
- Stow cockpit cushions on edge in cabin
- Ensure that stove switch and propane tank valve are closed
- Set all electrical switches to 'off'
- Set battery switch to 'off'
- Install companionway boards and lock
- Replace key in its proper position in the starboard lazarette
- Tighten steering brake with rudder in centered position
- Deploy the guppy, secure to rail, and attach clamp to backstay
- Secure lifeline gate when leaving the boat
For the dinghy before leaving the marina
- scrub floor
- freshwater rinse
- wipe salt residue from motor surfaces
- secure lock
- cover motor
After every few trips
- deck
- scrub the decks
- remove scuff marks from transom and aft hull
- freshwater rinse exterior above the waterline
- flush soot and dirt from toe rails
- head
- drain holding tank then flush it a few times
- scrub/wipe all surfaces
- clean drain pan and grid
- bilge
- scrub with brushes and rinse
- clean bilge well of any particles
- remove all slime and debris from pump strainers
- kitchen
- clean stove and oven
- clean sinks
- clean countertops
- main cabin
- wipe/scrub all wood surfaces with murphy's wood soap (diluted)
- wipe/scrub ceiling with simple green (diluted)
- wipe/scrub hatches and mast with simple green (diluted) to remove salt residue