Return checklist
From MITNA
Before leaving the boat
- On Deck
- As needed, rinse the deck, brightwork, and metal with fresh water
- Ensure that headsail is furled and secured, cover is hoisted, and jib sheets are tight
- Replace cowl vents
- Confirm the mooring line is on and tied off
- Ensure the main halyard is attached to the deck fitting, not the head of the sail
- Stow winch handles in little deck boxes
- Ensure the engine key is off and removed
- Lash the rudder
- Tie a lateral line to the aft end of the boom to prevent it from swinging
- Remove tension from the hydraulic backstay
- Ensure all flags are stowed
- Place and secure canvas covers on forward hatch, jib furling line hole, mainsail, cabin (including cushion), aft hatch, and backstay
- Below Deck
- Check that the head is clean and empty
- Confirm all hatches (3) and port lights (2) are closed and secured (at least with bungees)
- Ensure the sink seacock is closed
- Remove all trash from the boat
- Sweep/wipe all cabin, kitchen, and cockpit surfaces as needed
- Ensure all circuit breakers are off
- Complete log entry, including:
- Date and time
- Fuel level (push the black button on the engine panel)
- Engine hours (digital display in the tachometer)
- Name of person making the entry
- Description of trip, including destination, route, weather
- Anything else the next skipper should know (repairs needed, issues, etc.)
For the dinghy before leaving the marina
- scrub floor
- freshwater rinse
- wipe salt residue from motor surfaces
- Stow motorboat key in lockbox on dock
After every few trips
- deck
- scrub the decks
- remove scuff marks from transom and aft hull
- freshwater rinse exterior above the waterline
- flush soot and dirt from toe rails
- head
- drain holding tank then flush it a few times
- scrub/wipe all surfaces
- clean drain pan and grid
- bilge
- scrub with brushes and rinse
- clean bilge well of any particles
- remove all slime and debris from pump strainers
- kitchen
- clean stove and oven
- clean sinks
- clean countertops
- main cabin
- wipe/scrub all wood surfaces with murphy's wood soap (diluted)
- wipe/scrub ceiling with simple green (diluted)
- wipe/scrub hatches and mast with simple green (diluted) to remove salt residue
- dinghy
- scrub bottom of dinghy