(by person)

Edit to show progress...

Greg:

• Repair keel - Greg. Greg has made good progress, Franny will push for him to complete the keel for launch.
• Paint bottom.

Greg should provide guidance wrt bottom, mast/boom and topsides painting.

Lloyd:

• Fix engine oil leaks - Lloyd. Lloyd says he’s on this; I’ll keep pushing him. No real Plan B if Lloyd doesn’t move on this; I think we need to pull the engine to do the job right.

Eric:

• Remove corrosion on mast and boom; repaint - Eric We should work on the boom and the mast. No progress on this yet that I know of.
• Binnacle light - Eric (can be done after splash)

Scott:

• Engine maintenance (change oil/various filters/replace raw water pump) - Scott. Have all the parts.
• Replace nuts on rear quarter fittings - Scott
• New blocks for mainsheet - Scott These are on the baot.
• New shackles to fasten traveler adjusting blocks to car - Scott.
• Inspect running rigging - Scott. Done. Need to take a length of rigging to the riggers for work.
• Take pfds/harnesses/jacklines/foulies/radios&plugs/puck compass/ditch bag/laptop/iPad to boat. Halyards and blocks on boat.

Ted:

• Replace damaged NMEA terminator for anemometer on masthead - Ted
• Inspect steering gear, grease rudderpost - Ted
• Condition batteries - Ted. I have no idea where this is at.
• Cetol woodwork - Ted. Scott applied a couple of coats of Cetol to the worst parts last Fall; we should put on a couple of coats more.

Adam:

• Repair dodger - Adam
• Get main, #1, #3 and spinnaker from North

Tim:

• Restitch wheel cover

Other:

• Take cushions from pav to boat (shortly before launch)
• Take boom to boat
• Inflate red dinghy, coat with ArmorAll, move to Waterboat.
• Clean, buff and Propspeed prop (think there is propspeed at the pav)
• Replace prop shaft zincs