Nevermore Task List
From MITNA
If a task is yours and you have additional information about it, please make a page for that task, assign it to the Maintenance Tasks Category, and post updates.
Tasks with a Point Person
- TO DO BEFORE MAST RE-STEP
- replace mast light (mwall, asilveira)
- replace radar antenna and cable (WHO?)
- replace tricolor lens at top of mast (may be the anchor light? or strobe?) (WHO?)
- (See also undo winterizing)
- (Check also in Unclaimed Tasks below (and sign-up for one!))
- TO DO BEFORE Spring 88 REFLOAT
- replace head output thru-hull fitting (when boat is out of water)
- Replace traveller (See fix traveller page] (mwall)
- get boat surveyed (fcharles) - DONE - surveyed 04Dec
- scan it (and put on wiki? or just put aboard Nevermore? (fcharles)
- (See also undo winterizing)
- (Check also in Unclaimed Tasks below (and sign-up for one!))
- renew coast guard documentation (fcharles)
- make new cushion covers (mwisheart)
- install new bilge pump float switch (tyoung)
- new switch arrived and ready to be installed
- diagnose and document electrical system (tspettel & tyoung)
- ongoing See 12-volt DC in Systems List
- DONE See Engine schematic dgm engine 12-volt schematic]] (ref'd by engine Systems List)
- ongoing See 120-volt AC System in Systems List
- ongoing 110v charging system task description/discussion
- DONE: study/describe and testing of 110V charging of batteries
- TODO: test the "blue-wire" charging-inhibition circuit which activates when engine runs
- TODO: write up operator steps for normal use
- procure new emergency and first-aid kit (asilveira)
- fix screens (tyoung)
- inventory what is on boat (samajane)
- procure & change engine fluids: (ThomS) - doing as part of Winterizing
- fresh water coolant antifreeze - DONE - Nov07
- engine oil and filter - DONE - Nov07
- transmission fluid
- we decided to haul boat first, THEN OOPS! can't run xmission to change fluid when out of water,
- so will do in spring after splash
- other engine periodic maintenance (not repairs) (ThomS)
- replace engine pencil-zincs - DONE - Fall/Winter '07/'08
- clean/replace fuel filters
- pick some other chores not done for winterizing, but are on webs ref'd in Winterizing page
- START a "periodic maintenance schedule (maybe based on [Aleida's] list we were mulling
- Install binnacle GPS power and data connectors (tyoung)
- replace missing screw on base of furler (tspettel)
- get binnacle compass bubble out
- remove compass and take to Fran at pavilion
- take to get it repaired (fcharles)
- replace freshwater hoses (mwall)
- repaint name and hailing port on stern once our USCG documentation has been renewed (ksovie)
Cleaning Tasks
- clean kitchen again/more (samajane)
- ongoing see below
- clean/tune stove and oven (tyoung)
- main cabin
- scrub all wood surfaces with murphy's wood soap (diluted)
- scrub ceiling of main cabin
- starboard lazarette
- remove everything from lazarette then scrub it (use brushes), then put everything back when the lazarette has dried out
- aft lazarette
- remove everything from lazaretted (including wood panels) then scrub the hull and wood panels
- head
- remove everything from cupboards and scrub them out
- scrub all surfaces in the head
- holding tank needs to be drained then flushed a few times
- scrub the hull under the sink. beware of the outbound thru-hull fitting - it leaks already and we do not want to sink the boat by knocking it off or exacerbating the leak.
Unclaimed Tasks
- TO DO BEFORE RESTEPPING MAST
- replace top-of-mast light filter/cover
- rewire mast lights
- reinstall RADAR antenna & wiring
- inspect top-of-mast furler, stays' swagers, etc
- TO DO BEFORE Spring 08 REFLOAT
- fix wind indicator
- diagnose and tune depth indicator and sensor (dive under boat to clean?)
- outfit dinghy (boat, boards, motor)
- cut new foam for cushions (see mwall for specs on foam)
- replace faulty head seals (NOTE: head tune-up kits are aboard)
- replace all head hoses
- install led lighting (rcleary has some details of replacement parts)
- de-scale mast (in cabin)
- tighten lifelines
- sand and refinish topside brightwork (mwall has the cetol for this)
- secure nav light wiring in anchor compartment
- spec and order new speedometer
- wiring needs to be tidied up, specifically raised to be further from water levels
- bonding system of boat needs inspection/repair/upgrade
- diagnose, tune, and document radar/chartplotter system
- replace manual bilge pump (handle socket is fractured)
- install capture wires on anchor retention pin(s)
- fix blower and move its hose to bilge
- build shelves for storage under v-berth
- build shelf for storage under nav berth
- build slots for holding washboards
- supplement sides of starboard lazarette to prevent items from falling under engine
- add zippers or windows to bimini so you can see the sails.
Completed Tasks
- get boat to boston :) (mlindblad, fcharles, asilveira, rcleary, smgarrel, mwall)
- remove unused stuff from boat (asilveira, rcleary, mwall)
- clean kitchen equipment (asilveira)
- procure freshwater pumps (rcleary)
- install freshwater pump (tyoung)
- lubricate door fittings (mwall)
- clean curtains (asilveira)
- 12v batteries and switches documented (tspettel)
- repair bilge pump and move to stern lazarette (tyoung)
- diagnose engine instruments (tspettel & tyoung)
- scrub inside of port cabin bench DONE (samajane/lfortmiller)
- scrub inside of port nav station compartment (beneath and to the left of the nav table) (samajane)
- scrub inner hull surfaces and vertical surfaces in the clothing cabinets (located near the head) (samajane/lfortmiller)
- repair faulty tachometer (tyoung)
- repair torn bimini (tyoung)
- scrub inside of freshwater tanks (samajane/tyoung/asilveira/rcleary)
- install new freshwater manual pump (twanderer)
- remove stove hoses and replace with new hoses (tyoung)
- purge stove fuel tank, clean, and reinstall (tyoung)
- install new shroud protection (mwall)
- procure life jackets (asilveira)
- sand down to fit, & revarnish, 3 saloon sole hatches (tspettel)
- scrub topsides to remove scuffs, epoxy, and mildew (and peanuts) (mwall)
- put line on steering wheel for grip and centering (mwall)
- blue one installed short-term. might install something more extensive later.
- scotchbrite topside stainless fittings (pulpit, stanchions, anchor tray) to remove rust (mwall)
- bilge
- after everything else has been cleaned, the bilge needs to be scrubbed with brushes and flushed numerous times (ksovie)
- replace fresh air intake cowl (dorade) on deck (ksovie)
-
fix/tune/replace traveller- SUBSUMED into "replace traveler" task