(by person)

Edit to show progress...

Greg:

Repair keel - Greg. Greg has made good progress, Franny will push for him to complete the keel for launch.
Paint bottom.

Greg should provide guidance wrt bottom, mast/boom and topsides painting.

Fix engine oil leaks - Lloyd. Lloyd says he’s on this; I’ll keep pushing him. No real Plan B if Lloyd doesn’t move on this; I think we need to pull the engine to do the job right.

Remove corrosion on mast and boom; repaint - Eric We should work on the boom and the mast. No progress on this yet that I know of.
Binnacle light - Eric (can be done after splash)
Touch up topsides paint - Eric. Ditto wrt Greg. Our topsides Awlgrip color is Cabernet Burgundy as far as I can tell - Greg has a set of color samples. He might have a few touch-up kits; he said he would order a few last spring for this purpose. Buffing the topsides is part of this.

Engine maintenance (change oil/various filters/replace raw water pump) - Scott.
Replace nuts on rear quarter fittings - Scott
New blocks for mainsheet - Scott These are in hand.
New shackles to fasten traveler adjusting blocks to car - Scott.
Inspect running rigging - Scott.
Take halyards/pfds/harnesses/jacklines/foulies/blocks/radios&plugs/puck compass/ditch bag/laptop/iPad to boat.

Replace damaged NMEA terminator for anemometer on masthead - Ted
Inspect steering gear, grease rudderpost - Ted
Condition batteries - Ted. I have no idea where this is at.
Cetol woodwork - Ted. Scott applied a couple of coats of Cetol to the worst parts last Fall; we should put on a couple of coats more.

Sails (new asym, re-cut #1 and #3, new #4, main with flattening reef). The sails are being finished up. Brad says the main/#1/#3 are ready to be picked up.
Take cushions from pav to boat (shortly before launch)
Take boom to boat
Inflate red dinghy, coat with ArmorAll, move to Waterboat.
Clean, buff and Propspeed prop (think there is propspeed at the pav)
Replace prop shaft zincs