Difference between revisions of "Fix mast toplight (task)"
From MITNA
(Wiring complete) |
|||
| Line 30: | Line 30: | ||
** Strobe: 14 AWG Blue | ** Strobe: 14 AWG Blue | ||
| + | == June 1, 2008 Status == | ||
| + | |||
| + | * Wires at the top of the mast encased in heat-shrink for protection. | ||
| + | * Quikfits socket re-mounted to top of mast. | ||
| + | * New wires attached to Quikfits socket. | ||
| + | * Protective over placed over Quikfits socket. | ||
== To Do == | == To Do == | ||
| − | * | + | * Immediately before the mast is stepped, the tricolor should be clipped to the Quikfist connector. |
Revision as of 08:41, 2 June 2008
Fall 2007 Status
The light fixture at the top of the mast is broken.
It is believed to be an Aqua Signal Series 40 Tricolor/Anchor/Strobe light (12v, w/ Quicfits connector).
All three lamps are in working order (2 incandescent & 1 strobe). It may be possible to replace just the lenses to get the fixture working again properly. The Aqua Signal part number for the lens assembly is 40710-1.
Four wires run to this fixture from the base of the mast. These should be inspected for corrosion and replaced if necessary.
May 28 2008 Status
- New lens fixture ordered and received.
- 4 new wires run through mast:
- Ground: 12 AWG Yellow
- Tricolor: 14 AWG Red
- Anchor: 14 AWG Grey
- Strobe: 14 AWG Blue
June 1, 2008 Status
- Wires at the top of the mast encased in heat-shrink for protection.
- Quikfits socket re-mounted to top of mast.
- New wires attached to Quikfits socket.
- Protective over placed over Quikfits socket.
To Do
- Immediately before the mast is stepped, the tricolor should be clipped to the Quikfist connector.
