Difference between revisions of "Engine schematic dgm"
(minor rewrite technical & words) |
m (needn't link to old Redirect) |
||
| Line 1: | Line 1: | ||
| − | ::(return to Systems Descriptions of the [[ | + | ::(return to Systems Descriptions of the [[Systems Descriptions#engine | Engine]] or [[Systems Descriptions#12-volt DC | 12-volt DC]].) |
(See NOTES related to ''Nevermore'''s configuration of engine circuits located after the right-hand part of the diagram later below.) | (See NOTES related to ''Nevermore'''s configuration of engine circuits located after the right-hand part of the diagram later below.) | ||
Revision as of 23:20, 26 December 2007
- (return to Systems Descriptions of the Engine or 12-volt DC.)
(See NOTES related to Nevermore's configuration of engine circuits located after the right-hand part of the diagram later below.)
Engine electrical schematic diagram from Tartan manual
(Above) Left-hand side of page Q.2 of schematic in Tartan Tech Manual
(See NOTES related to Nevermore's configuration of engine circuits located after the the diagram below.)
(Above) Right-hand side of page Q.2 of schematic in Tartan Tech Manual
NOTES related to Nevermore's engine wiring configuration:
- See page Q.2 right-hand side for the SCHEMATIC INSERT for Westerbeke 50 engine's starter and glow-plugs. This diagram replaces the INSERT on the left-side schematic. Nevermore has 4 glow-plugs, not a pre-heater, and has a starter with integral solenoid; the starter's "-" is grounded within the starter, which is bolted to the engine.
The 2 user-provided CktBrkrs (parts 45 & 46, discussed in written notes circle-B and circle-C), are located toward the back of the engine, and can be seen from the companionway area when viewed over the oil catch basin under the engine. The two reset buttons are visible on a metal bracket, and the "10" and "40" amperage ratings are somewhat visible.
- The optional SPLITTER (part 44) is not installed. We believe that Nevermore's schematic can be read with a metal connection between terminals "A" and "1" on the splitter on the schematic.
- Tech Manual page V.11 Service Bulletin #87 discusses adding the optional splitter. To account for voltage drop across the splitter, it says to "connect regulator wire directly to alternator output rather than to the regulator terminals". (Thom can't make sense of this on the schematic without the Svc Bull 22Sep07).
- TODO: Per above note, (1) see if Svc Bull. #87 shows the "...regulator wire..." connection, and (2) see if we need to make a NOTE that changes the wiring at the alternator in the schematic above to agree with NOT having the splitter installed.
- Fuel pressure switch, note circle-G:
- This switch is discussed in the Nevermore Tech Manual page V.15, Service Bulletin #94. It MAY discuss how to attach remotely located switches into the fuel-pressure fluid circuit.
- This switch is shown in the Parts List page 214 as item #33, attached to the Injection Pump item #41 via adaptor #32 and other little hardware; it's also shown on page 218 as item #6, seemingly the same configuration as the #214 picture with all the same little fiddly parts.
- Written note circle-I isn't operative, since the control panel IS installed.
