Difference between revisions of "Nevermore Task List"

Revision as of 14:40, 5 October 2007 (view source) ThomS (Talk | contribs) m (sole hatches varnished; refer 120-volt project to Sys List 1st-cut doc'n) ← Older edit		Revision as of 14:46, 5 October 2007 (view source) ThomS (Talk | contribs) m (noted some leak stopped head outflow thru-hull) Newer edit →
Line 79:		Line 79:
	* diagnose (and replace?) head out thru-hull fitting (when boat is out of water)		* diagnose (and replace?) head out thru-hull fitting (when boat is out of water)
		+	:: tightened it mid-Sep, lots of leaking abated, some seepage still - ThomS
	* install led lighting (rcleary has some details of replacement parts)		* install led lighting (rcleary has some details of replacement parts)

---

Revision as of 14:46, 5 October 2007

If a task is yours and you have additional information about it, please make a page for that task, assign it to the Maintenance Tasks Category, and post updates.

Tasks with a Point Person

• renew coast guard documentation (fcharles)

• outfit dinghy (boat, boards, motor) (sporter)

• put line on steering wheel for grip and centering (mwall)

• replace mast light (mwall, asilveira)

• replace traveller line (mwall)

• make new cushion covers (mwisheart)

• fix screens (tyoung)

• documentation of systems (samajane)
  • ongoing

• install new bilge pump float switch (tyoung)
  • Franny says it's on order

• diagnose and document electrical system (tspettel & tyoung)
  • ongoing

• procure new emergency and first-aid kit (asilveira)

• arrange for out-of-water winter storage (fcharles)

• inventory what is on boat (samajane)

• procure engine coolant (sporter)

• change oil and coolant (sporter)

• clean kitchen again/more (samajane)
  • ongoing see below

• clean/tune stove and oven (tyoung)

• Install GPS power and data connectors (tyoung)

• replace freshwater hoses (mwall)

Cleaning Tasks

• main cabin
  • scrub all wood surfaces with murphy's wood soap (diluted)
  • scrub ceiling of main cabin

• starboard lazarette
  • remove everything from lazarette then scrub it (use brushes), then put everything back when the lazarette has dried out

• aft lazarette
  • remove everything from lazaretted (including wood panels) then scrub the hull and wood panels

• head
  • remove everything from cupboards and scrub them out
  • scrub all surfaces in the head
  • holding tank needs to be drained then flushed a few times
  • scrub the hull under the sink. beware of the outbound thru-hull fitting - it leaks already and we do not want to sink the boat by knocking it off or exacerbating the leak.

• bilge
  • after everything else has been cleaned, the bilge needs to be scrubbed with brushes and flushed numerous times

Unclaimed Tasks

• find a place to store her over the winter

• replace faulty head seals

• replace all head hoses

• diagnose (and replace?) head out thru-hull fitting (when boat is out of water)

tightened it mid-Sep, lots of leaking abated, some seepage still - ThomS

• install led lighting (rcleary has some details of replacement parts)

• purge holding tank

• de-scale mast (in cabin)

• tune rigging

• tighten lifelines

• lubricate turnbuckles

• replace sad ringdings

• apply rigging tape to ringdings/cotter pins (after rig tuning and rd replace)

• sand and refinish topside brightwork (mwall has the cetol for this)

• secure nav light wiring in anchor compartment

• install speedometer (The speedometer has disappeared)

• fix wind indicator

• wiring needs to be tidied up, specifically raised to be further from water levels

• bonding system of boat needs inspection/repair/upgrade

• diagnose and tune depth indicator and sensor (dive under boat to clean?)

• diagnose, tune, and document 12v system

• diagnose, tune, and document 110v system

[see [Systems-List 3.3.2] 1st-cut documentation]

• diagnose, tune, and document 110v charging system

• diagnose, tune, and document radar/chartplotter system

• diagnose/change engine oil and oil filter

• replace manual bilge pump (handle socket is fractured)

• install capture wires on anchor retention pin(s)

• fix/tune/replace traveller

• fix blower and move its hose to bilge

• build shelves for storage under v-berth

• build shelf for storage under nav berth

• build slots for holding washboards

• supplement sides of starboard lazarette to prevent items from falling under engine

• repaint name and hailing port on stern once our USCG documentation has been renewed.

• add zippers or windows to bimini so you can see the sails.

Completed Tasks

• get boat to boston :) (mlindblad, fcharles, asilveira, rcleary, smgarrel, mwall)

• remove unused stuff from boat (asilveira, rcleary, mwall)

• clean kitchen equipment (asilveira)

• procure freshwater pumps (rcleary)

• install freshwater pump (tyoung)

• lubricate door fittings (mwall)

• clean curtains (asilveira)

• 12v batteries and switches documented (tspettel)

• repair bilge pump and move to stern lazarette (tyoung)

• diagnose engine instruments (tspettel & tyoung)

• scrub inside of port cabin bench DONE (samajane/lfortmiller)

• scrub inside of port nav station compartment (beneath and to the left of the nav table) DONE (samajane)

• scrub inner hull surfaces and vertical surfaces in the clothing cabinets (located near the head) (samajane/lfortmiller)

• repair faulty tachometer (tyoung)

• repair torn bimini (tyoung)

• scrub inside of freshwater tanks (samajane/tyoung/asilveira/rcleary)

• install new freshwater manual pump (twanderer)

• remove stove hoses and replace with new hoses (tyoung)

• purge stove fuel tank, clean, and reinstall (tyoung)

• install new shroud protection (mwall)

• procure life jackets (asilveira)

• sand down to fit, & revarnish, 3 saloon sole hatches: 3 sanded & fit (tspettel)