|
|
| (110 intermediate revisions by 2 users not shown) |
| Line 3: |
Line 3: |
| | Please use the discussion page to discuss the prioritization and content of any of these tasks. | | Please use the discussion page to discuss the prioritization and content of any of these tasks. |
| | | | |
| − | == Pre-storage (fall) tasks == | + | ==Sailing Season Projects== |
| − | * Lay out all sails and look for any issues | + | *Fix Running Lights |
| − | * Wipe down all surfaces to reduce mold/mildew. (Vinegar? Peroxide? Bleach? Wood soap?) | + | *Cotter pins for shroud turnbuckles |
| − | * Remove PFDs, lines,
| + | |
| − | * Dry the spare lines, spinnakers, and anything else that’s wet, especially if they will be stored somewhere without air circulation
| + | |
| − | * Inspect all sails, lines, rig hardware, and spars before storing them for the winter
| + | |
| − | * Inspect and inventory safety gear, medical kit, etc.
| + | |
| − | * Inventory spare parts and make list of needed replacements
| + | |
| − | * Scrub bilges around engine with Joy to remove fuel leak residue
| + | |
| − | * Scrub overhead above refrigerator to remove mildew
| + | |
| − | * Remove knives -- Gavin to resharpen
| + | |
| − | * Remove all cutlery, plates, pots, etc.
| + | |
| | | | |
| − | = Dion's Work = | + | ==2024-25 Offseason work == |
| − | ==Centerboard== | + | |
| − | *Plan is to pull the board right away when hauled.
| + | |
| − | *Grind off head until it swings easily through wood on top of the lead keel while swelled up. Put the boat back into water to make certain it swings freely with the box wet and swollen up. Remove board again and glass up properly and install downhaul line up through the tube to the cabin top as well. New bright red paint.
| + | |
| − | *Get 1" half oval from Hamilton for Gasket Plates. Two 8' pieces... Cut to fit. Drill and counter sink for 1/4" screws on drill press. Install gasket beneath. Mark edges then, remove and re-cut gasket with hot knife. Then finally install...
| + | |
| | | | |
| − | == Rigging, Hull, Motor == | + | ===Projects from observations=== |
| − | * Replace spreader lights - convert to LEDs with lower profile, mount them better. Dions | + | *New mainsail cover |
| − | * We need a new (3rd) cowl vent, one went missing at the start of the season. Dions | + | *Patch or replace main hatch cover |
| − | * Inspect all standing rigging, grease Furlex bearings top and bottom
| + | *New mast boot cover |
| − | * All the hatch hinges need to be strengthened, replaced and/or repaired. We had water intrusion and loss of almost all of them this year (I think it was time catching up to them?) Dions
| + | *Major dinghy repair or replacement |
| − | * The forward hatch teeth (the part attached to the hull that the latch goes in) needs to be re-attached. Thru bolted in bronze pls Dions
| + | *Re-affix hardware on main cabin skylight |
| − | * The whole inside of the hull needs to be gone over, especially in the cockpit lockers. There was significant mold/mildew buildup. Dions in Spring? | + | *Varnish the tiller |
| − | * Scrub bilges around engine with Dawn or Joy to remove fuel leak residue | + | *Replace the starboard bow light (is this separate from fixing it for the season?) |
| − | * Scrub overhead above refrigerator to remove mildew | + | *Consider the main halyard chafe--this will likely need replacement |
| − | * Create a way to hold the lid under the forepeak berth open when rummaging for supplies. Dions
| + | *Clean paddlewheel (speed sensor?) |
| − | * Topsides touch-up again? Re-paint next year? Check plank ends at transom, please.
| + | *Download B&G data |
| − | * Bottom paint, What brands are best? Sea Hawk?
| + | *Messenger lines for halyards |
| − | * Varnish- Cabin top, toe rails, coamings, tiller, companionways, hatches, spars- Interior surfaces? | + | |
| − | * Motor- Change oil and filter. Leave spare filter on board
| + | |
| − | * Replace low-pressure engine oil line near on-engine fuel filter that has a nick and slow oil leak. It is getting worse. (+ reattach to prevent chafe; check other lines for potential chafe). | + | |
| − | * Check forward starboard engine mount- seems off | + | |
| − | * Polish fuel tank- Boat should arrive with less than 1/3 tank
| + | |
| − | * Purge water systems and flush/ bleach | + | |
| − | * Fresh o rings and gaskets on fuel fill, fresh water fill and holding tank | + | |
| − | * Flush and purge poop tank? Boat will arrive fully pumped out | + | |
| − | * Replace or repair two bent stanchions
| + | |
| | | | |
| − | = North Work = | + | ===Projected work based on routine intervals=== |
| − | * We need a new canvas boot for the mast-deck connection. North. | + | *Inspect sails; make worklist |
| − | * Two little covers for furler line port. North | + | *Inspect running rigging; make replacement list |
| − | * 140 work: Luff tape torn, need to buy a pre-feeder, Shorter aft batten along 140 foot | + | *Inspect standing rigging (us or Dions?); assess lifespan |
| − | * Big red spin- tear near clew repaired | + | *Replace last two inflatable PFDs (2024 will be their 10th season) |
| − | * Mainsail cover inspected and repaired as needed | + | *Renew mast varnish |
| | + | *Winterize engine |
| | + | *Oil and filter change on engine |
| | + | *Change raw water impeller on engine |
| | + | *Winterize and clean fuel/fuel tank |
| | + | *Winterize and clean the head |
| | + | *Launder interior fabrics |
| | + | *Clean boat thoroughly |
| | | | |
| − | = Other outsource = | + | ==Completed Tasks== |
| − | *Code Zero - must work with current hardware. Sleeve - to fit cable. | + | *Clean the dinghy motor propeller |
| − | *New #3 jib?
| + | |
| − | * Second spinnaker halyard done properly - consistent in diameter
| + | |
| − | * Replace dyneema topping lift?
| + | |
| | | | |
| − | = MIT Work = | + | ==Task Lists from Past Seasons== |
| | | | |
| − | == Random Work ==
| + | 2023-2024: [[Task_List_2023-24|here]] |
| | | | |
| − | * Buntlines for main sail reefing (these are the lines that pass through the grommets in the sail)
| + | 2022-2023: [[Task_List_2022-23|here]] |
| − | * Bungees on head hatch - Gavin
| + | |
| − | * Mounting for compass? New compass?
| + | |
| − | | + | |
| − | == Sails==
| + | |
| − | | + | |
| − | * Working jib - bolt rope on the luff frayed near the head - maybe not needed if replacing?
| + | |
| − | | + | |
| − | ==Rigging==
| + | |
| − | * Replace jib sheet - same diameter, length + 1' - maybe just fix?
| + | |
| − | * Whipped jib sheet ends
| + | |
| − | * Replace or end for end the main sheet
| + | |
| − | * Cunningham purchase system to easily be soft shackled on when needed - carabiner?
| + | |
| − | * Longer jib furling line to let us lead it aft? Soft shackle fairlead?
| + | |
| − | * Winches broken down and greased - Gavin
| + | |
| − | * Jib prefeeder - us
| + | |
| − | * New cable for spinnakers
| + | |
| − | * Tack line hardware for attaching spin roller furler to a jamming bight - delay for now?
| + | |
| − | * Ring-dings for turnbuckles
| + | |
| − | * Replace all cotter pins
| + | |
| − | * Double smaller block for jib halyard. - Us
| + | |
| − | | + | |
| − | == Shopping List ==
| + | |
| − | * purchase some of those blue grippy gloves or similar for the boat to have for people to use
| + | |
| − | * Purchase more sail ties that are extra-long -- webbing -- Fran
| + | |
| − | * Procure more hand sanitizer for onboard use
| + | |
| − | * Procure more hangers for the foulies (maybe wood? or stronger plastic)
| + | |
| − | * Procure origo dometic 3000 rubber gasket for top of fuel container - https://www.atlanticmarinesupply.com/product/dometic-environmental-3880036-00-rubber-gasket/
| + | |
| − | * Procure a few more mugs for onboard use
| + | |
| − | * Procure a metric socket set for onboard tasks (e.g. engine work)
| + | |
| − | * Procure some chamois for proper clean-up
| + | |
| − | * Procure a pool noodle (or something else) for storing the battens
| + | |
| − | * Purchase new self-sealing washer for fuel stop solenoid and replace: Volvo Part 21424327
| + | |
| − | * Purchase Extra racor filters and a
| + | |
| − | | + | |
| − | ==Miscellaneous==
| + | |
| − | * Handle to replace capstan? Get Fran a drawing
| + | |
| − | * Housing for the radar reflector—a bag or permanent hook or both
| + | |
| − | * Figure out anti-fouling for the dinghy motor (doesn't tilt far enough up to keep prop out of water).
| + | |
| − | * Anti-foul the dinghy bottom
| + | |
| − | * All the dinghy glue
| + | |
| − | * Replace eye for lee cloth on port berth
| + | |
| − | * Repair screen on the starboard porthole
| + | |
| − | * More permanent repair to companionway screen (+ better place to store)
| + | |
| − | * Replace flag on end of windex triangle
| + | |
| − | * Winch handle release issue -- can we fix this?
| + | |
| − | * Shave bilge panels for easier access?
| + | |
| − | * Grease companionway tracks
| + | |
| − | * Spruce up soundproofing around the engine
| + | |
| − | | + | |
| − |
| + | |
| − | ==Radar and electronics==
| + | |
| − | * Base for radar mount?
| + | |
| − | * Full electronics meeting to follow. Radar/new MFD, etc? Both B&G and Raymarine reps just recommended getting a new raymarine radar. To replace the MFD we’d also need to replace a lot of the sensors around the boat.
| + | |
| − | * New Raymarine radar so that we can it to display on the chart plotter?
| + | |
| − | * Get rid of gremlins in the wireless displays (voltage boost?)
| + | |
| − | * Get touchscreen physical buttons properly working
| + | |
| − | * Get a new MMSI and reprogram everything so we don't conflict with "FUSION" on the west coast? -- AIS MOB, VHF, etc.
| + | |
| − | * Engine panel electrical gremlins - clean and reseat all contacts…
| + | |
| − | * Neaten up wiring to the chartplotter so that the "T" lives inside the cabinet
| + | |
| − | | + | |
| − | == Electrical ==
| + | |
| − | * High water bilge alarm should be rewired to also pump; right now if the lower switch fails the high water alarm will go off but the pump won’t run - Ted
| + | |
| − | * Cabin lighting -- LED and red/white option?
| + | |
| − | * Electrical panel -- replace LED "power on indicator" for running lights
| + | |
| − | | + | |
| − | ==Safety==
| + | |
| − | | + | |
| − | * Some safety provisions for short-handed and/or night time sailing?
| + | |
| − | * SOP + pictures of jackline setup
| + | |
| − | * Encourage all to take a Safety at Sea seminar this winter.
| + | |
| − | * Procure 3 re-arm kits for PFDs
| + | |
| − | * Procure an 3rd water-activated light for 3rd throwable
| + | |
| − | * Procure a pair of safety glasses for the tool kit
| + | |
| − | | + | |
| − | ==Mechanical==
| + | |
| − | * Create a video of changing and seating washers and gaskets properly?
| + | |
| − | * Check engine mounts -- stbd forward seems off
| + | |
| − | * Odd propeller sounds at high RPM. “Rumble” that’s off and 1/s oscillation sound.
| + | |
| − | * Purge water out of racor
| + | |
| − | | + | |
| − | | + | |
| − | == Spring (Pre-Launch) Tasks ==
| + | |
| − | * Manually inflate + inspect all PFDs
| + | |
| − | * Inventory + restock med kit
| + | |
| − | * Go over whole hull for mold/mildew
| + | |
| − | | + | |
| − | ==Next summer==
| + | |
| − | *Training sessions
| + | |
| − | * Skipper dry run for jacklines + MOB
| + | |
| − | | + | |
| − | == Completed Tasks ==
| + | |
| − | * Re-rig reefing hook to sit closer to the boom - Part is in the liquor locker drawers with a shackle on it.
| + | |
If a task needs additional explanation, please make a page for that task and post updates. When a task is completed, move it to the 'Completed Tasks' section, and include the date it was completed.
Please use the discussion page to discuss the prioritization and content of any of these tasks.
