Difference between revisions of "Shopping List"
From MITNA
Line 14: | Line 14: | ||
* hooks for fender stowage in port lazarette | * hooks for fender stowage in port lazarette | ||
* large anchor/rode bag | * large anchor/rode bag | ||
+ | * two boat hooks | ||
* stove | * stove |
Revision as of 10:13, 17 June 2012
Please add here parts and supplies that are needed for the boat.
needed
- pen holder for nav station
- window gasket - fuller brush company; 12 3/8 x 5 1/4 gasket; 13.5 x 6.5 approx cutout
- gasket material for raw water strainer - perko
- stainless mesh for raw water strainer - perko
- 2 large hose clamps for mast boot
- bag(s) for lines to be hung on mast
- wood dowels - 3/4" diameter and 1 1/8" diameter to plug toerail holes
- mesh bag(s) for lines to hang from mast
- hooks for line stowage in stbd v-berth bin
- hooks for fender stowage in port lazarette
- large anchor/rode bag
- two boat hooks
- stove
- propane hose 15'
- shutoff valve
- solenoid (pending inspection/refurb of previous)
- engine
- alternator belt 39.5" (40" should be ok) 25-9425
- transmission fluid: ?
- rigging
- spinnaker halyard: 1/2" line, ? feet
- main halyard: 1/2" line, ? feet
- jib sheets: ? line, ? feet
- 5 halyard blocks for 1/2" line (main, 2 spin, 2 jib)
- 2 blocks for 1/2" line (main sheet)
- 3 cheek blocks for 1/2" line (main halyard, main sheet)
- boom vang tackle: 352131 (Harken 8:1 Tackle YR-XL), West Marine part no. 7358880 - ordered 15jun12
- boom vang tube
- traveler car: harken T3242B.HL - ordered 15jun12
completed
- 16jun12 mast boot kit
- 16jun12 2 rolls oil blotter
- 16jun12 holding tank treatment 4 bottles
- 16jun12 large fender to replace uninflatable deflated one
- 16jun12 8 1.5" high quality hose clamps for scupper T fittings
- 13jun12 binder for manuals - keith has it, will deliver to boat 07apr12
- 12jun12 fiberglass insulation for exhaust riser
- 12jun12 blower exhaust vent
- 12jun12 coolant: ethylene glycol with sodium nitrate/benzoate, 2 gallons
- 12jun12 oil: 15W40, 5 quarts
- 12jun12 45 degree 1.25" elbow bronze for seawater in
- 12jun12 nuts and lockwashers for exhaust riser
- 11jun12 two oil hoses
- 20may12 1" to 1.25" bronze coupling (via threaded reducer)
- 19may12 starter motor - deliver to wally for rebuild 11may12
- 19may12 transducer paint
- 19may12 replacement screws for prop shaft coupling - will use old ones
- 17may12 30 stainless screws oval head phillips #12 3" long
- 16may12 traveler end controls
- 13may12 stainless cotter pin sets
- 13may12 stainless hinge for top cabin/engine step
- 13may12 lock washers for engine bracket 3/8"
- 13may12 stainless screws for engine mount 3/8", 1.5" long
- 13may12 exhaust thru-hull
- 13may12 engine seawater in hose
- 13may12 bronze fittings for engine seawater in
- 13may12 prop paint
- 10may12 bottom paint - 3 gallons black - at pavilion
- 08may12 exhaust riser for perkins engine - ready to install 01apr12
- 08may12 engine bracket and engine mount - ordered by wally foster ??mar12
- 22apr12 gojo hand cleaner
- 22apr12 bleach
- 22apr12 simple green
- 22apr12 dust masks
- 22apr12 misc electrical parts (wire, breakers, lamp fixtures)
- 22apr12 misc hoses and fittings for cockpit scuppers
- 22apr12 parts trays for fasteners
- ??apr12 hose for large manual pump
- 22apr12 fitting for exhaust thru-hull 1-3/4" thread to 2-3/8" barbed/smooth
- 01apr12 Y connector for 1-1/8" hose - ordered 01apr12 from jamestown
- ??apr12 JABSCO 29290-1000 strum box for 1" hose
- 01apr12 whale gusher 10 rebuild kit
- 01apr12 1" antisiphon loop (seawater in to engine)
- 01apr12 10' engine stop cable plus hardware
- 01apr12 6" length of 2" ID hose - on boat
- 01apr12 Ultra Safety Systems Ultimate Mini float switch - on boat
- 01apr12 bandaids - on boat
- 01apr12 large and small wire ties - on boat
- 01apr12 large and small nylon wire clamps - on boat
- 01apr12 propane regulator - on boat
- ??mar12 sponges - package of 6 on boat