Difference between revisions of "Nevermore Task List"
From MITNA
(→Tasks with a Point Person) |
(removed tasks that are either done, claimed, or no longer applicable) |
||
Line 69: | Line 69: | ||
* cut new foam for cushions (see mwall for specs on foam) | * cut new foam for cushions (see mwall for specs on foam) | ||
− | |||
− | |||
* replace faulty head seals | * replace faulty head seals | ||
Line 76: | Line 74: | ||
* replace all head hoses | * replace all head hoses | ||
− | * | + | * replace head out thru-hull fitting (when boat is out of water) |
− | + | ||
* install led lighting (rcleary has some details of replacement parts) | * install led lighting (rcleary has some details of replacement parts) | ||
− | |||
− | |||
* de-scale mast (in cabin) | * de-scale mast (in cabin) | ||
− | |||
− | |||
* tighten lifelines | * tighten lifelines | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
* sand and refinish topside brightwork (mwall has the cetol for this) | * sand and refinish topside brightwork (mwall has the cetol for this) | ||
Line 99: | Line 86: | ||
* secure nav light wiring in anchor compartment | * secure nav light wiring in anchor compartment | ||
− | * | + | * spec and order new speedometer |
* fix wind indicator | * fix wind indicator | ||
Line 108: | Line 95: | ||
* diagnose and tune depth indicator and sensor (dive under boat to clean?) | * diagnose and tune depth indicator and sensor (dive under boat to clean?) | ||
− | |||
− | |||
− | |||
− | |||
* diagnose, tune, and document radar/chartplotter system | * diagnose, tune, and document radar/chartplotter system | ||
− | |||
− | |||
* replace manual bilge pump (handle socket is fractured) | * replace manual bilge pump (handle socket is fractured) | ||
Line 136: | Line 117: | ||
* add zippers or windows to bimini so you can see the sails. | * add zippers or windows to bimini so you can see the sails. | ||
− | |||
− | |||
== Completed Tasks == | == Completed Tasks == |
Revision as of 06:09, 23 October 2007
If a task is yours and you have additional information about it, please make a page for that task, assign it to the Maintenance Tasks Category, and post updates.
Tasks with a Point Person
- renew coast guard documentation (fcharles)
- outfit dinghy (boat, boards, motor) (sporter)
- replace mast light (mwall, asilveira)
- replace traveller line (mwall)
- make new cushion covers (mwisheart)
- fix screens (tyoung)
- install new bilge pump float switch (tyoung)
- new switch arrived and ready to be installed
- diagnose and document electrical system (tspettel & tyoung)
- ongoing See 12-volt DC in Systems List
- done See link to engine 12-volt schematic in Systems List
- ongoing See 120-volt AC System in Systems List
- ongoing 110v charging system task description/discussion
- procure new emergency and first-aid kit (asilveira)
- inventory what is on boat (samajane)
- procure & change engine fluids: (ThomS)
- fresh water coolant antifreeze
- engine oil and filter
- transmission fluid
- clean kitchen again/more (samajane)
- ongoing see below
- clean/tune stove and oven (tyoung)
- Install GPS power and data connectors (tyoung)
- replace freshwater hoses (mwall)
Cleaning Tasks
- main cabin
- scrub all wood surfaces with murphy's wood soap (diluted)
- scrub ceiling of main cabin
- starboard lazarette
- remove everything from lazarette then scrub it (use brushes), then put everything back when the lazarette has dried out
- aft lazarette
- remove everything from lazaretted (including wood panels) then scrub the hull and wood panels
- head
- remove everything from cupboards and scrub them out
- scrub all surfaces in the head
- holding tank needs to be drained then flushed a few times
- scrub the hull under the sink. beware of the outbound thru-hull fitting - it leaks already and we do not want to sink the boat by knocking it off or exacerbating the leak.
- bilge
- after everything else has been cleaned, the bilge needs to be scrubbed with brushes and flushed numerous times
Unclaimed Tasks
- cut new foam for cushions (see mwall for specs on foam)
- replace faulty head seals
- replace all head hoses
- replace head out thru-hull fitting (when boat is out of water)
- install led lighting (rcleary has some details of replacement parts)
- de-scale mast (in cabin)
- tighten lifelines
- sand and refinish topside brightwork (mwall has the cetol for this)
- secure nav light wiring in anchor compartment
- spec and order new speedometer
- fix wind indicator
- wiring needs to be tidied up, specifically raised to be further from water levels
- bonding system of boat needs inspection/repair/upgrade
- diagnose and tune depth indicator and sensor (dive under boat to clean?)
- diagnose, tune, and document radar/chartplotter system
- replace manual bilge pump (handle socket is fractured)
- install capture wires on anchor retention pin(s)
- fix blower and move its hose to bilge
- build shelves for storage under v-berth
- build shelf for storage under nav berth
- build slots for holding washboards
- supplement sides of starboard lazarette to prevent items from falling under engine
- repaint name and hailing port on stern once our USCG documentation has been renewed.
- add zippers or windows to bimini so you can see the sails.
Completed Tasks
- get boat to boston :) (mlindblad, fcharles, asilveira, rcleary, smgarrel, mwall)
- remove unused stuff from boat (asilveira, rcleary, mwall)
- clean kitchen equipment (asilveira)
- procure freshwater pumps (rcleary)
- install freshwater pump (tyoung)
- lubricate door fittings (mwall)
- clean curtains (asilveira)
- 12v batteries and switches documented (tspettel)
- repair bilge pump and move to stern lazarette (tyoung)
- diagnose engine instruments (tspettel & tyoung)
- scrub inside of port cabin bench DONE (samajane/lfortmiller)
- scrub inside of port nav station compartment (beneath and to the left of the nav table) (samajane)
- scrub inner hull surfaces and vertical surfaces in the clothing cabinets (located near the head) (samajane/lfortmiller)
- repair faulty tachometer (tyoung)
- repair torn bimini (tyoung)
- scrub inside of freshwater tanks (samajane/tyoung/asilveira/rcleary)
- install new freshwater manual pump (twanderer)
- remove stove hoses and replace with new hoses (tyoung)
- purge stove fuel tank, clean, and reinstall (tyoung)
- install new shroud protection (mwall)
- procure life jackets (asilveira)
- sand down to fit, & revarnish, 3 saloon sole hatches: 3 sanded & fit (tspettel)
- scrub topsides to remove scuffs, epoxy, and mildew (and peanuts) (mwall)
- put line on steering wheel for grip and centering (mwall)
- blue one installed short-term. might install something more extensive later.
- scotchbrite topside stainless fittings (pulpit, stanchions, anchor tray) to remove rust (mwall)